Count the bubbles of gas given off by pondweed under different conditions
The experiment
Rate of photosynthesis
100%75%50%25%0%
0%
of the plant's maximum rate
Steady
The pondweed has been damaged by heat. Some of the enzymes in its cells have denatured, so it cannot photosynthesise as well as before, even if you cool the water down again.
Conditions
Light intensity
%
050100
CO2 concentration
ppm
0420 (air)10001500
Temperature
°C
01020304050
Measure
Clock speed
Write your name and set the conditions. Wait until the rate meter says Steady, then count.
Graph
Change only the variable on the x-axis between counts. When you change one of the other two variables, the next counts start a new line on the graph.
Results table
Rate of photosynthesis is measured as the number of bubbles counted per minute. The highlighted column is the variable on the graph's x-axis.
How to use the bubble lab
Decide which variable you are going to test: light intensity, carbon dioxide concentration or temperature. Keep the other two the same.
Set the first value. When you change a condition the plant takes a little while to adjust, so wait until the rate meter says Steady.
Press Count bubbles for 1 minute. The bubbles are counted as they pass the count line in the funnel neck, and the result is added to the table.
Change your variable by one step (for example from 100% to 90% light) and count again. Carry on until you have a full set of results.
Pick the graph that matches the variable you changed. To compare, change one of the other variables (for example raise the CO2 to 1000 ppm) and repeat. Your new results form a second line.
The clock speed only makes the minute pass more quickly. The plant behaves the same way at every clock speed, so the counts can be compared.
Water that is too hot damages the pondweed. If that happens you can start again with fresh pondweed.
Your results are kept in this browser, so they are still there if you reload the page. Each count is also sent to your teacher with your name.